Můžete se přihlásit anebo si založit konto
CZK Košík

ELECRAFT K2 KV transceiver*

ELECRAFT K2 KV transceiver*
Stavebnice špičkového KV (80-10m) CW transceiveru

Cena s DPH 27 750,00 CZK

Cena bez DPH22 933,88 CZK

ks
Odkazy
Stavebnice špičkového KV TCVRu, včetně podrobného manuálu.
Základní konfigurace s pásmy 80-10m, CW. Pásmo 160m, SSB a další moduly lze dokoupit.

CENA JE ORIENTAČNÍ - V ZÁVISLOSTI NA ZMĚNÁCH KURZU USD
-----
K2 STANDARD FEATURES
Rugged, attractive custom enclosure

Small, portable size: 2.9h x 7.8w x 8.2d inches

Weight 3.3 lbs. (excluding internal options)

80-10 meter ham band+ coverage; 160 m optional

Efficient 12 Volt (10 - 15 V) operation for home or field

Receive current as low as 150 mA (battery save mode)

CW-only or SSB/CW + Digital Modes with SSB option

Back-lit LCD and LED bargraph; day/night settings

PLL synthesized--low phase noise
Microprocessor controlled

3 transverter bands; programmable display, I.F., power
Dual VFOs with split operation.

Direct keypad entry of frequencies and memory channels.

RIT and XIT with four offset ranges

Built-in high-efficiency speaker

Memories store mode, VFO A/B, split, RX filter, etc.

Simple menu system for advanced settings. (Up to two menu functions can be assigned to the two programmable front panel function keys.)

Room for additional connectors on the rear panel

Smart #hunt and pounce# band-scanning mode

RECEIVER
Low-noise, single-conversion superhet receiver

Double-balanced diode mixer for excellent dynamic range

Receive sensitivity: 0.15 uV (pre-amp on, typical.)

Narrow ham-band, double-tuned bandpass

RX/TX filters, relay switched for better IMD response

Smooth, fast attack, I.F.-derived AGC (no "popping")
Switchable preamp and attenuator

Variable-bandwidth I.F. crystal filtering

Multiple VFO tuning rate selections

10 Hz tuning resolution

Bar graph S/RF OUT/ALC meter

Adjustable squelch

TRANSMITTER
Adjustable 0.1-15 W (K2), 0.1 # 100W (K2/100)

Rugged, SWR-protected, push-pull PA transistors
Programmable current limit for battery operation
Harmonics and spurious outputs: Better than #40 dBc

CW FEATURES
Full diode switched break-in with variable QSK delay (Both at QRP and 100W levels)

9-memory keyer; iambic A and B; adjustable weight

9-50 wpm (internal keyer); 70+ wpm (external keying)

Programmable message repeat interval
Simultaneous computer and paddle CW keying inputs

Variable bandwidth crystal filter (approx. 200 - 2000 Hz)

Adjustable RX CW offset with tracking TX side tone.

Selectable opposite sideband RX for QRM reduction